80 deg C Boiling Point, <100 deg F Flash Point

This product is compatible with most chemicals normally used in swimming pool maintenance. However, in its concentrated form, this chemical must not come in contact with high concentrations of chlorine or any other oxidizer. Do not mix this product and chlorine or any other oxidizer together before adding to the pool. These chemicals must be handled separately. This product was formulated to complement most swimming pool sanitizers. This product is not a stand alone product. It must be used with either halogen-based or non-halogen-based pool sanitizers. When using other products as outlined in directions for this product, always follow directions on those products. This product requires no special equipment for treating swimming pool water. The correct use dilution may be added directly to the pool in any spot or added to the water circulation equipment. This product works the best when added by itself directly to pool water by pouring around entire outside perimeter of pool. Do not allow swimming in pool for at least 15 minutes after this product has been applied. Ensure all pool equipment is working properly. Backwash the filter system following manufacturers directions. Adjust pH between 7.2 to 7.6. Adjust chlorine residual to 1 to 3 ppm. In a chlorine treated pool, add stabilizer to establish a minimum level of 40 to 50 ppm to reduce the degradative effects of sunlight upon the chlorine residual. Check for metals and if present add stain and scale inhibitor to prevent staining of pool surface due to metals. Check chlorine residual and adjust to 1 to 3 ppm. Maintain sanitizer residual in accordance with label directions found on your sanitizer of choice. Ensure that water quality conditions are maintained for the successful use of the product.