• By filtering less oil, typically around 1 gph vs 20 gph, you dramatically extend filter life With Tigerloop®, the oil travels slowly into the house (at around 1 gph) and loops through the Tigerloop® and pump multiple times, picking up heat before it is fired Contrast this to a two-pipe system where cold oil enters the house rapidly (20 gph) and then is immediately sent back outside into the cold tank again (this also stirs up sediment in the tank, which can clog nozzles and filters) Without the pressurized return line that is constantly pumping oil back to the tank, Tigerloop® dramatically reduces the risk of leaks Vacuum pulls vapor right-out of the oil even in an "air-tight" system Less vacuum means less air which means clear, foam-free oil at the nozzle Installing a Tigerloop® cuts the flow rate down the firing rate of the system, typically 1 gph, dropping vacuum and improving burner efficiency while putting less strain on your oil pump and motor With a two-pipe system, all of the air and fuel in the line flows through the pump, flows by (or out) the nozzle and then gets returned all the way back to the tank The Tigerloop® de-aerates the returning fuel before sending it back to the pump reducing air by up to 95% and improving efficiency The flame will sputter less, the burner will fire cleaner and prevent deposits on the heat exchanger which can build-up and interfere with the absorption of heat In a single pipe system, all air in the line has to go out the nozzle So installing a Tigerloop® will dramatically improve efficiency

Tigerloop® oil deaerator eliminates many common oil heating problems which prevent a burner from operating at peak performance by removing air from the system, delivering foam-free fuel to the nozzle and reducing issues caused by cold fuel benefits which ultimately provide for cleaner, maximized combustion. The Tigerloop® oil deaerator improves the efficiency and extends the life of your oil heating systems. The Tigerloop® combines the benefits of a single pipe system with a two-pipe system. With a Tigerloop® installed, you need only to transport oil at the nozzle firing rate (i.e. 1 gph). This allows you to use one small line from the tank to the Tigerloop®, whereas with a two-pipe installation you have to provision two-large diameter lines that will handle oil traffic at approximately 20 gph in both directions.